廠家東道防爆LED防爆燈LED防爆加油站燈防爆油井燈防爆燈殼體
廠家東道防爆LED防爆燈LED防爆加油站燈防爆油井燈防爆燈殼體
廠家東道防爆LED防爆燈LED防爆加油站燈防爆油井燈防爆燈殼體
品牌：東道防爆 型號：DOD 輸入電壓：100-240（V）
LED燈珠顆數：99（顆） 封裝工藝：單顆式 LED芯片品牌：普瑞
光通量：10000（lm） 色溫：6000-6500（K） 燈具光效：120（lm/W）
功率因數：≥0.95 發光角度：120（度） 顯色指數：75
防護等級：IP65 認證：防爆認證，專利認證， 使用場合：油、化工、工廠、煤礦、隧道等易燃醫爆氣體環境中的安全照明。
尺寸：335*275*150（mm） 壽命：100000（H） 外殼材質：鋁合金
重量：9000（g） 功率：1250 燈光顏色：正白
光源類型：LED
適用范圍 Application
SDB48-L適用于ⅡA、ⅡB類含有爆炸性氣體或蒸汽環境，溫度組別為T1-T6的1區、2區室內外危險場氣或20區、21區、22區爆炸性或可
燃性粉塵場所室內外照明。
It is applicable for explosive gas or steam atmospheres of CAT ⅡA, ⅡB , temperature classification from T1 to T6, is mainly applied to Zone
1 and Zone 2 hazardous locations indoors and outdoors, or explosive or combustible dust atmospheres Zones 20, 21 and 22, used for lighting indoors and
outdoors.正常工作條件 Normal working conditions
◆安裝地點的海拔不超過2000m；
◆周圍環境溫為-40℃～+40℃，且24h內的平均溫度值不超過+35℃;
◆周圍空氣相對濕度不大于95%(+25℃)
◆在無劇烈振動、沖擊及搖動的地方；
◆適用于1區、2區、ⅡA、ⅡB、ⅡC類及T1～T6組爆炸性氣體環境場所；
◆Altitude of the installation site shall not beyond 2000m;
◆Ambient temperature should be within -40℃～+40℃, average temperature within 24h shall not exceed +35℃;
◆Ambient air relative humidity shall not exceed 95% (+25℃);
◆Installation site shall be free of severe vibration, shock or shake;
◆It is applicable for explosive gas atmospheres Zones 1 and 2, CAT ⅡA, ⅡB and ⅡC, and temperature classification from T1 to T6.
產品結構性能 Product structure performance
1、燈具防爆型式為隔爆型或粉塵防爆型，適用于氣體或粉塵爆炸危險場所照明使用，
2、燈具由光源腔，電器腔構成密閉式設計。
3、燈具由鋁合金壓鑄成型，電器腔內含LED電源，接線端子等電器，光源腔內部設有鏡面反射器。
玻璃采用鋼化玻璃，透光率高，抗沖擊強。網罩采用不銹鋼，表面聚酯粉末噴涂(防腐型外殼經過特殊金屬外處理再表面聚酯粉末噴涂)。
4、燈具外露緊固件采用鋁材，安裝有橡膠密封墊，密封可靠，防水防塵防腐性強。內置橡膠件，電線外皮，塑料全采用抗高溫抗 阻燃件，更安全可靠。
5、本燈具適用于管吊式，吸頂式、吸壁式、立桿式、支架式多種安裝方式。
6、電源采用整體散熱技術，短路、過流、過壓、過溫保護。
7、燈具具有命、高亮度抗震性好、外觀美觀大方，長期使用免維護。是節能、環保理想的防爆燈具。1、燈具防爆型式為隔爆型或粉塵防爆型，適用于氣體或粉塵爆炸危險場所照明使用，
2、燈具由光源腔，電器腔構成密閉式設計。
3、燈具由鋁合金壓鑄成型，電器腔內含LED電源，接線端子等電器，光源腔內部設有鏡面反射器。
玻璃采用鋼化玻璃，透光率高，抗沖擊強。網罩采用不銹鋼，表面聚酯粉末噴涂(防腐型外殼經過特殊金屬外處理再表面聚酯粉末噴涂)。
4、燈具外露緊固件采用鋁材，安裝有橡膠密封墊，密封可靠，防水防塵防腐性強。內置橡膠件，電線外皮，塑料全采用抗高溫抗
阻燃件，更安全可靠。
5、本燈具適用于管吊式，吸頂式、吸壁式、立桿式、支架式多種安裝方式。
6、電源采用整體散熱技術，短路、過流、過壓、過溫保護。
7、燈具具有命、高亮度抗震性好、外觀美觀大方，長期使用免維護。是節能、環保理想的防爆燈具。
1. The lamp is of flameproof or dust explosion-proof type, is suitable for gas or dust explosion hazardous locations.
2. By the light source of lamps and lanterns cavity, electrical constitute a closed cavity design.
3. Lamps by aluminum alloy die-casting molding, electrical cavity embedded LED power supply, terminals such as electronics, light source cavity with
internal mirror reflector.USES toughened glass, high transmittance, strong impact resistance. Net is made of high quality stainless steel, the surface
of polyester powder coating (anti-corrosion type shell with special metal processing and surface polyester powder coating).
4. The exposed fasteners are made of high quality stainless steel, are equipped with rubber gasket, with reliable sealing performance, excellent waterproof,
dustproof and anti-corrosive properties. Built-in rubber parts, wire jacket, and plastics all use high-temperature resistant and flame retardant articles,
safer and more reliable.
5. All kinds of installation ways are suitable, such as hanging type, ceiling type, wall-mounted type, post type, bracket type, etc.
6. The power supply adopts integral heat dissipation technology, with protections against short circuit, over current, over voltage, over heat, etc.
7. The lamp enjoys long service life, high brightness, good antiknock characteristic, elegant appearance, maintenance free. It is an ideal product for energy
saving and environment protection. 使用與維護 The use and maintenance
◆防爆燈在使用前，要仔細檢查銘牌內容與客戶訂貨是否相符合；
◆防爆燈在安裝時先將進線電纜通過引入裝置接到接線腔的接線端子上，并壓緊密封圈，使電纜密封好，接好接地線，緊固好螺釘，上述
各項檢查無誤后，即可通電使用；
◆防爆燈不得隨意拆卸，維護時，須斷開前級電源后才可開蓋檢修；一般不需要檢修本產品具有命特點。
◆在維修過程中不得損壞隔爆面，維修后涂204-1防銹油，合好蓋，緊固后方可使用；
◆防爆燈應定期檢查，清理透明件表面灰塵。
◆障礙物距防爆外殼大于30mm。
◆Before putting into operation, please check the nameplate first to make sure that the parameters are what you ordered.
◆Before installing the lamp, please connect the incoming cable to the terminal block in the wiring chamber through the entry device, compress the seal
ring, well connect earth wire, and tighten the screws. Examine and make sure everything is right, then switch on the power supply;
◆Don't disassemble the lamp randomly, when repairing, must cut off the power supply first before opening the cover for maintenance; usually it need
not to repair, as it is featured with long service life.
◆Pay attention to not hurt the explosion-suppression surface during maintenance, coat with anti-rust oil 204-1 after maintenance, close the clover,
make sure to tighten it before using;
◆Inspect the lamp regularly, clear away the dust from the transparent parts.
◆Distance from the explosion-proof shell to the obstacle should be more than 30mm.

售后服務期：

　　公司先后通過了船級社ISO9001質量管理體系認證，國家燈具質量監督中心等機構認證。產品保用5年產品，整燈保用2年。自購買之日起2年內，產品正常使用下出現任何故障，由本公司負責免費維修，2年后僅收取材料費。
江蘇常州

查看全部介紹